This is a brand new BOSS air bag load assist kit + In Cab Kit PX01 (Inflation Kit) to suit the rear of:
Toyota Hiace Van & Toyota Hilux 2WD right up to the current 2016+ model
The Load Assist Kit comes with:
- 2 x BOSS Extreme Series Double Bellow Airbags
- 4 x brackets (2 upper & 2 lower)
- Mounting Hardware
- Quality SAE J844 Government Approved Airline
- Dual Schrader Valves Mounted in Stainless Panel
- Instructions for fitting
Boss Extreme series airbags are rated at 2500lb or 1136kg per side and have been government approved tested to over 750psi.
All Boss airbags are manufactured by us and are branded Boss. Beware of unbranded airbags, usually coming from China from other companies.
Average dual cab ute will run around 15-45psi depending on load.
Boss has sold over 13000 load assist kits in Australia, proven over time with 4WD enthusiasts, Mining companies, Tradies, 4WD Tour Operators as well as in Agricultural Vehicles, Trailers and motorhomes, limited only to your imagination.
To get the best performance from your kit inflate airbags just enough to achieve a level ride height. By doing this you are also allowing all of the suspension components to share the extra load of the vehicle and not putting any unecessary pressure on any one individual part of your vehicles suspension.
THIS PACKAGE DEAL INCLUDES THE AIR BAG LOAD ASSIST KIT ALONG WITH THE PX01 IN CAB KIT (Inflation Kit)
The In Cab kit includes the BOSS PX01 Compressor, gauge and controls. As soon as you turn the compressor on, it inflates the 2 air bags. The one-way valves prevent air transferring from one bag to the other so that you have a better ride. A gauge with twin needles is also included as well as a manual dump valve for deflating each bag separately.
This kit is used to control Load Assist Kits from inside your cab without the need for a tank and electric valves.
Simple installation and controls bags independently up and down using our PX-01 compressor.
- 1 x PX-01 12V BOSS Air Compressor.
- 1 x Stamped stainless steel gauge panel.
- 2 x Pneumatic Push Buttons for dropping each bag.
- 1 x 12V momentary switch for compressor.
- 1 x BOSS 200psi Dual Needle back-lit Gauge.
- 10 meters of 1/4” J844 DOT Airbrake line.
- 2 x 1/4” push connect check valves.
- 3 x Y Connectors.
- 2 x T Connectors.
- 4 x 1/4” female push fittings for gauge and buttons.
- 10 x Cable Ties.
- Instruction Sheet.
SAVE TIME AND MONEY WITH THIS ALL-IN-ONE AIR BAG LOAD ASSIST KIT & PX-01 COMPRESSOR (IN CAB KIT)