This Strut Spacers 20mm Lift Suitable For Toyota Prado 120/150| FJ Cruiser| Hilux and Foton Tunland.

These spacers are simply bolted to the top of the strut to provide approximately 20mm of lift.

You remove the coil from the strut and the spacer fits between the coil spring and the strut top using the supplied bolts.

You will need a coil compressor to remove the coils safely.

Superior Engineering has designed these as a cheap alternative to correct sag after fitting a bull bar| Dual batteries or other heavy accessories.

Laser-cut from 10mm plate steel for precise fit and zinc coated.

Although they are 10mm thick they will lift the front end up by 20mm over the axles.

Supplied with:

• 2 x 10mm strut spacers
• 6 x M10x1.25 x 40mm button head bolts
• 6 x M10 Nylocks
• 6 x M10 Flat washers

SOLD AS A KIT.

Note: It is only recommended to use strut spacers on standard length struts| if you use longer struts ( aftermarket) then you must check down travel| make sure the cv's do not bind and there are no fouling issues with steering components and no steering components move past there maximum working angles.